Multi-Function Reset Button - NETGEAR GC108P Hardware Installation Manual

Insight Managed 8-Port Gigabit (Hi-Power) PoE+ Smart Cloud Switch with NETGEAR FlexPoE Power

Multi-function Reset button

The switch provides a recessed multi-function Reset button on the front panel so that
you can either restart (power-cycle) the switch, reset the switch to the most recently
saved cloud-managed configuration, or return the switch to its factory default settings,
causing all custom settings to be erased. The factory default settings function of the
Reset button is available only after you use the NETGEAR Insight app to remove the
switch from your network.
To restart or reset the switch or return the switch to its factory default settings:
1. Insert a device such as a straightened paper clip into the opening.
2. Do one of the following:
• Restart the switch. Press the Reset button for about two seconds. (Do not press
the button for more than five seconds!)
The switch restarts but retains its custom settings. During this process, the
Power/Cloud LED lights amber.
• Reset the switch to the most recently saved cloud-managed configuration.
Press the Reset button for at least five seconds.
The switch restarts and returns to the most recently saved cloud-managed
configuration. During this process, the Power/Cloud LED lights amber.
• Return the switch to its factory default settings. After you use the NETGEAR
Insight app to remove the switch from your network, press the Reset button for
at least five seconds.
The switch restarts and returns to its factory default settings. During this process,
the Power/Cloud LED lights amber.
Hardware Overview 16 Hardware Installation Guide