Replacing The Outer Surface Of Roller - M. J. MAILLIS GROUP SIAT BeeWrap Operation And Maintenance Manual

Replacing the outer surface of roller

▀
– The operation must be carried out by the maintenance technician or by person-
nel with suitable competences, skills and knowledge.
– Make sure to fulfil the required requirements in order to work under safe condi-
tions.
– This service should be carried out with the reel holding carriage lowered and the
machine safely at a stop.
1. Lift the lever A to its vertical position.
2. Remove the fastening elements and
remove the lever.
3. Remove in a sequence the compo-
nents B-C-D.
4. Remove the component F.
5. Unscrew screw G.
6. Unscrew the nuts H.
7. Remove the plate L.
8. Remove stop ring M.
9. Remove the component N.
10. Remove all the external cylinder sur-
face inserts P, one at a time.
11. Thoroughly clean the grooves of the
roller.
12. Insert in a sequence, one at a time,
all the new external cylinder surface
inserts.
13. Install component N.
14. Reinstall the retainer ring M.
15. Fit back the plate L and fix it with the
nuts H without tightening.
16. Insert screw G and tighten it.
17. Adjust the position of the plate L and
tighten the nuts H.
18. Install component F.
19. Install in a sequence the compo-
nents D-C-B.
20. Engage the lever A in a vertical posi-
tion and insert the fastening elements.
21. Lower the lever to its horizontal position.
– At the end of operations, check that there are no tools or other material near the
moving parts or in dangerous areas.
Operation and maintenance manual
Reel holding carriages
English language
65