M. J. MAILLIS GROUP SIAT BeeWrap Operation And Maintenance Manual page 38

– Audible warning device is activated
to warn that the machine is operat-
ing.
– The machine stops as previously de-
scribed, based on the selected type
of wrapping.
Press button H to stop wrapping;
press button G to continue.
Wrapping will start at the point where
it has been stopped.
– Single mode: the wrapping stops
automatically with the reel holder
carriage at the upper side of the load.
– Insert the covering sheet.
– Press the key G to complete the
wrapping of the covering sheet.
Press button L to move reel holder
carriage to the start of the cycle (low-
er part).
– Double mode: the wrapping stops
automatically with the reel holder
carriage at the upper side of the load.
– Insert the covering sheet.
– Press key G.
– The machine completes the wrap-
ping cycle and stops automatically
with the reel holder carriage at the
lower side of the load.
11. Manually cut the film and cause it to
adhere to the wrapped product.
Important
Keep the reel suitably refilled to pre-
vent to avoid interrupting the wrapping due to absence of film.
12. Use the buttons S to lean the roller feeler A against the load to be wrapped.
13. Press button G to start the wrapping cycle.
– Audible warning device is activated to warn that the machine is operating.
– The machine performs the new wrapping and, at the end of the set cycle, stops auto-
matically.
14. Repeat the same steps for the rest of the loads.
15. At the end of the working activity, adjust the buttons S to park the machine within the
battery charging area.
16. Carry out battery recharge (See "Charge of accumulator batteries").
36
English language
Use and functioning
Operation and maintenance manual