Related Manuals for ring RSC404
Summary of Contents for ring RSC404
- Page 1 Intelligent Battery Charger 6V/12V 4A Suitable for 12V Lead Acid, Gel, Calcium, AGM and EFB batteries between 10-120Ah Instructions...
-
Page 2: Important Safety Instructions
7. Remove personal metal items such as rings, bracelets, necklaces, and watches when working with a lead-acid battery. A lead- acid battery can produce a short circuit current high enough to weld a ring or the like to metal, causing a severe burn. -
Page 3: Control Panel
CONTROL PANEL 1. The icon will indicate 2A Charge Rate, which is used for charging the small capacity batteries used in motorcycle, ATV, snowmobile, personal watercraft, garden tractor and golf car. 2. The icon will indicate 4A Charge Rate, which is used for faster charging of small-to-large capacity automotive, marine, deep cycle and farm tractor batteries. -
Page 4: Preparing To Charge
OPERATING INSTRUCTIONS PREPARING TO CHARGE a. If necessary to remove battery from vehicle to charge, always remove the grounded terminal from battery first. Make sure all accessories in the vehicle are off, so as not to cause an arc. b. Be sure area around battery is well ventilated while battery is being charged. c. - Page 5 g. When disconnecting charger, disconnect AC cord, remove clamp from vehicle chassis, and then remove clamp from battery terminal. h. See operating instructions for length of charge information. FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE. A SPARK NEAR THE BATTERY MAY CAUSE BATTERY EXPLOSION.
- Page 6 CHARGING NOTE: Before using the charger, please review all safety and connection directions. Failure to do so can damage battery and cause serious injury or death. · Connect the charger to battery per the operating instructions. · Connect the charger to AC outlet. ·...
- Page 7 ADDITIONAL FEATURES a. REVERSE POLARITY PROTECTION The REVERSE POLARITY INDICATOR LED will light and the power will not be sent to output cables if a reverse connection is detected. b. SHORT CIRCUIT PROTECTION This protection is triggered if the charger detects less than 0.5V across the clamps, and no power will be sent to output cables. Refer to Error Code of “Er1”...
-
Page 8: Troubleshooting Error Codes
They can take this product for environmental safe recycling. Ring Automotive Limited, Gelderd Road, Leeds LS12 6NA ENGLAND Tel: +44 (0)113 213 2000 Fax: +44 (0)113 231 0266 Email: autosales@ringautomotive.com...