Troubleshooting Error Codes; Maintenance Instructions; Technical Data - ring RSC404 Instructions Manual

TROUBLESHOOTING ERROR CODES

Error code
Er1
Er2
Er3

MAINTENANCE INSTRUCTIONS

This charger requires minimal maintenance. As with any appliance or tool, a few common sense rules will prolong the life of the
battery charger.
ALWAYS BE SURE THE CHARGER IS UNPLUGGED BEFORE PERFORMING ANY MAINTENANCE OR CLEANING.
1. Store in a clean, dry place
2. Coil up the cords when not in use.
3. Clean the case and cords with a slightly damp cloth.
4. Clean any corrosion from the clamps with a solution of water and baking soda.
5. Examine the cords periodically for cracking or other damage and have them replaced if necessary.
6. WARNING: All other service should be done by qualified personnel only.

TECHNICAL DATA

Model RSC404
Input 220 - 240V AC 50Hz
Output 6V DC 2A 12V DC 2/4A
Ring Automotive Limited, Gelderd Road, Leeds LS12 6NA ENGLAND
Tel: +44 (0)113 213 2000
Email: autosales@ringautomotive.com
Website: www.ringautomotive.com
Condition
The battery voltage is less than 0.5V
before charging.
The charge does not begin.
The battery voltage is 0.5V - 1.5V
before charging.
The battery voltage is less than 11V
after 4 minutes of charging. The bat-
tery is not full charged after 24-hour
charge.
The battery voltage is less than 12V
in 2 minutes after full charged.
The temperature of the charger is
too high.
RECYCLING
This marking indicates that this product should not be disposed with
other household wastes throughout the 2012/19/EU. To prevent possible
harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return
and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
Fax: +44 (0)113 231 0266
Possible Cause
The battery is defective.
The battery clamps are disconnected
with the battery. The battery clamps
are connected to each other.
The battery voltage is not matched
with the selected mode.
The battery is defective.
The battery is defective.
A load may be connected to the
battery.
The charge current is too low.
The battery is sulphated beyond
reconditioning.
High ambient temperature.
Solution
Replace the battery.
Connect the battery firmly and
correctly.
Confirm that battery voltage is
matched with the mode.
Replace the battery.
Replace the battery.
Disconnect the load and attempt to
charge again.
Select a higher charge rate.
Replace the battery.
Ensure adequate ventilation. The
charger will resume charging after
cooling.
L493