Table of Contents
Advertisement
®
Busch-Welcome
4
Set the address of the preferred outdoor stations and the address of the indoor station on the rotary switches
(see chapter "Addressing" on page 36).
Fig. 27:
5. Set the master/slave function and the terminal resistor on the switches at the rear of the top part of the
housing (see chapter "Setting the master/slave switch" on page 29).
Fig. 28:
6.
Latch the upper part of the device onto its bottom part. To do this, place the upper side of the device on
the lock-in lugs and then press the bottom side onto the bottom part of the device until the clamp catches.
The installation of the indoor station is now complete.
| 2CKA001473B7474
ON
1 2
3
0
1
M/S
Mounting / Installation
ON
1 2
RC
— 34 —
Advertisement
Table of Contents
