Electrical Installation; Touch-Screen Version Scd 1297-Xt - Siemens SCD 1297-E Operating Instructions Manual

2.4

Electrical Installation

Before connecting the SCD 1297 to the power supply, a check should be carried out as to
whether the VGA connector is plugged in properly and that the screws are tightened.
There are many possible reasons why an image might fail to appear on the display after it
has been switched on:
• no VGA signal connected
• no synchronization signal connected
• horizontal and vertical synchronization signals are connected the wrong way round
2.5

Touch-screen version SCD 1297-xT

SW driver is needed for the operation of the Touch. It can be downloaded form the web page:
www.siemens.com/displays
LCD-Monitor SCD 1297
Page 36 / 44
Operating Instructions
DOC-No.: B30141DE3.DOC