Power Supply
Power is supplied to the SCD 1597-R/RT/R8S via a standard power connector on the rear of
the unit.
Pin
Name
O
GND
+12V
2.4. Electrical Installation
Before connecting the SCD 1597-R/RT/R8S to the power supply, a check should be carried
out as to whether the VGA connector is plugged in properly and that the screws tightened.
The monitor can be connected directly to the power supply (note the polarity of the supply). If
a video signal is connected, the image will appear immediately on the screen.
There are many possible reasons why an image might fail to appear on the display after it
has been switched on:
–
no video signal connected
–
no synchronisation signal connected
horizontal and vertical synchronisation signals are connected the wrong way round
–
2.5 Touch-screen version SCD 1597xx/T
The installation of the necessary touch screen driver software is described in the
manufacturers original touch-screen manual which is enclosed.
LCD-Monitor SCD 1597-R/RT/R8S
Description
Voltage input GND
Power supply +12VDC
Page 12 / 22
Operating Instructions
DOC-Nr.: B3 0038 D4.DOC