Audiolab LIVE 24 XL User Manual page 9

Digital Out
7. Automix Press this button to activate the
Automix function. The Automix automatically
reduces the level of a microphone when it is
not being used. Consequently it lowers the
rumble, reverberation and other extraneous
noise that occur when several microphones
operate simultaneously.
8. Pan Knob The encoder controls signal level
from left to right for the selected input chan-
nel. The LCD display shows the setting in real
time. If two channels have been linked as
stereo pair, the LCD display will automatically
change to stereo pan.
9. Assign Press this button to enter assign page,
signal from a selected input channel can be
assigned to Main, AUX1-8, and FX1-2. The
window is as below. For the detail operation,
please refer to introduction of DSP Control
section.
Automix
Assign
10. Gate Noise gate attenuates signals that be-
low the threshold and allows signals to pass
through only when they are above a thresh-
old setting. The window is as below. For the
detail operation, please refer to introduction
of DSP Control section.
11. Comp A compressor reduces the level of an
audio signal if its amplitude exceeds a cer-
tain threshold. The window is as below. For
the detail operation, please refer to intro-
duction of DSP Control section.
12. PEQ An equalizer is a filter that allows you to
adjust the level of frequency in the range of
20Hz-20KHz. The window is as below. For the
detail operation, please refer to introduction
of DSP Control section.
13. Channel Press this button, you will see
Channel page on LCD screen. It gives you a
preview of other function such as Polarity,
Delay, Link, Gate, EQ, Compressor etc. You
can also adjust corresponding parameters
that show on the screen. But for Gate here,
you can only adjust threshold; For Compres-
sor, you can only adjust threshold; For EQ,
you can adjust nothing here. For the detail
operation, please refer to introduction of
DSP Control section.
P. 9
- AUDIOLAB Live 24 XL
English version