Audiolab LIVE 24 XL User Manual page 24

Touch anyone of these controls to enter corre-
sponding page.
It is the same with that in Assign inter-
face in section "Assign interface".
Note: you can also rename the selected
channel by long pressing CHXX.
PEQ interface
Touch the switch to engage or disen-
gage the equalizer for the selected
channel. It will illuminate to indicate
that the equalizer has been touched and enabled.
The LCD display shows the EQ setting in real time.
Its parameters can adjust by sliding the curve on
the screen directly or using up & left & down &
right key to choose the function that you want to
modify and use the Parameter Adjust knob to set
the value. Please notice that only if the EQ button
has been enabled can its parameters be adjusted.
The equalizer is available for all input and output
buses.
Touch it, a dialog box saying " Are you
sure to flat the EQ? " will prompt to
check with you, if you click "yes", all the
setting values in this page will restore to default,
while choose "no" can keep your settings.
P. 24
AUDIOLAB Live 24 XL -
English version
Touch it to set the center frequen-
cy of the equalizer's Low/Low-mid/
High-mid/ High band separately. The
center frequency is the middle of the pass-band
between the lower and upper cutoff frequencies
which define the limits of the band. The center
frequency can be set from 20Hz to 20K Hz.
Touch it to set the Q for the Low/Low-
mid/High-mid/High band separately.
The Q is the ratio of the center fre-
quency to the bandwidth. If the center
frequency is constant, the bandwidth is inverse-
ly proportional to the Q, which means that if you
raise the Q, the bandwidth will be narrowed. It
can be adjusted from 0.4 to 24.
Touch it to set the gain cut or boost at
the center frequency for the Low/Low-
mid/High-mid/High band separately. It
can be set from -24 to +24 dB.
This is a high-pass filter. It can pass
higher frequencies. When set to its
lowest position, the filter is off. Type
indicates the filter's type that you selected, dif-
ferent type means different shape and different
filter frequency range.
This is a low-pass filter. It can pass low-
er frequencies. When set to its highest
position, the filter is off. Type indicates
the filter's type that you selected, different type
means different shape and different filter fre-
quency range.
Touch EQ1 to set its Frequency, Q and Gain
parameters separately, touch Type to change
the filter to high-pass, low-pass or band-pass
filter, the same as EQ2, EQ3 and EQ4. You can
see the waveform on
the screen. Note: you
can also rename the
selected channel by
long pressing CHXX.