Audiolab LIVE 24 XL User Manual page 12

19. Mixer Press this button, you will see mixer
page on LCD screen, where you can control
all the input and output channels' level, solo
and mute, as well as DCA group level control,
the window is as below. For the detail opera-
tion, please refer to the introduction of DSP
Control section.
20. Enter(TAP) This button can activate two
types of function.
• Enter: Confirm the edited parameter val-
ues. When there is a confirmation mes-
sage jump out on the screen, press Enter
button to answer "yes".
• TAP: In the FX1 and FX2 page, it will
switch to TAP function, you can use this
button to enter a delay time in tempo
with the music being played. As the func-
tion of this button will be a little bit differ-
ent in different function, please notice the
notes that are shown on the screen when
operating.
21. UP & Down & Left & Right button These
buttons move the cursor around the display
page, or select and delete parameters and
options. Sometimes, Up button function is
the same as Left button, while Down button
function is the same as Right button. But in
GEQ, Up and Down adjust gain level, while
Left and Right adjust frequency. As the func-
tion of this button will be a little bit different
in different function, please notice the notes
P. 12
AUDIOLAB Live 24 XL -
English version
Mixer
that are shown on the screen when operating.
22. Adjust Parameter Knob This Encoder
adjusts the parameter values of selected
control that are shown on the LCD display.
Turning it clockwise increases the value and
counterclockwise decreases the value. As
the function of this button will be a little bit
different in different function, please notice
the notes that are shown on the screen when
operating.
23. Solo Press this button will send its channels
or buses to the control room outputs. It will
illuminate as has been pressed and enabled.
24. Mute Press this button will mute selected
channel and all of its assigned outputs. It will
illuminate when the button has been pressed
and enabled.
25. Select Button There are 12 select buttons as
you can see on the panel. Press this button
will route its channel to add DSP setting and
assign its output. It will illuminate as has
been pressed and enabled. Press "1-12" but-
ton, which means CH1-12 correspondingly,
press "13-24" button, which means CH13-24
correspondingly, and press "Levels" button,
which means AUX1-8 and FX1-2 correspond-
ingly. In DCA window, you can select group
channels by this button.
26. Volume Fader There are 13 faders on the
panel which is used for level adjustment of
the corresponding channel, including 12 fad-
ers for CH1-24 and 1 for Main.
27. S Clear Press this button to clear the solo func-
tion for all of the soloed buses or channels.
28. M Clear Press this button to clear the mute
function for all of the muted buses or channels.
29. Stereo Link Press this button to select the
Pan function, then rotate Parameter Adjust
encode to control signal level from left to
right for the selected input or output bus. If
you have adjusted a channel pan, please just
touch 2 times on the screen and make it back
to the centre position. The LCD display shows
the setting in real time. If two channels have
been linked as stereo pair, the LCD display