Linear Tube Audio Z10 Series User Manual page 4

Quick Start
Remove Z10i from the box.
Attach the power cable to the IEC connector and plug into an
outlet. Turn the power switch next to the IEC connector on. This will
not turn the Z10i on (unless you have Power-on Override turned on,
which you can do in the menu).
Hook up your sources and speakers.
Once your system is set up and everything is hooked up, turn on
your Z10i via the power button on the front panel. The buttons are
capacitive, so you only need to touch them, they do not push in.
There is a turn-on delay of several seconds to allow the unit to
warm up.
It is usually best to turn your components on starting from the
beginning of the signal path and ending at the amplifier, and to
turn your system off in reverse order.
Operation
The unit is designed to be powered on indefinitely without harm.
The front panel power button powers down the amplifier but the
power supply remains on in a nearly idle state. To turn the amp
completely off, use the power switch next to the IEC connector.
The unit is air cooled and should be placed somewhere with
adequate ventilation.