Advertisement
INSTALLATION LOCATION
Tail
Light
Hatch
Handle
Car
Plate
Adjust
Viewing
Angle
Remarks :
1. Pictures are for illustration purpose only, see actual vehicle for accurate installation location.
2. Ensure diameter of hole size is correct before drilling.
3. Ensure drilling process does not harm the component of the vehicle.
4. Assign mounting location that will not obstruct camera view.
1
Remove one side of
the reverse light
socket from its
housing then remove
the bulb from its
socket.
1
Use a screwdriver
to remove the original
hatch handle
1
Remove the rotating
mount before instal-
lation. Drill an access
hole for the
camera cables
6
2
Connect the reverse
light power cable to
the camera, screwn
the housing & camera
back into position
with a screwdriver.
2
Mount the camera
where the original
hatch handle used
to be
2
Mount the camera
onto the acces hole
& secure it in position
with 3M tape/ screws
Advertisement
