Warning Led Setup - Unipro UniGo 5005 User Manual

32
C o n f i g u r i n g
Setup mode
t h e L a p t i m e r
Setup run mode screens. Run mode 2
shown here.
Move around between the different channel
fields with the and up ( ) and down ( )
buttons. The active channel field is clearly
marked with a rectangle around it. To change
the channel, simply press the the ok button
( ) to bring up the channel select popup.
Select the channel from the popup window.
All avaiable channels are listed including the
not so typical ones like "engine timer" and
"none". Accept the new channel by pressing
the ok button ( ).

WARNING LED SETUP

The 5 LEDs are all programmable. This is done
from the warning LED setup menu. There is
one menu for each warning LED.
Warning LED menu. LED blinking at the
same time.
When moving around in the setup menu, the
corrosponding LED will blink to make it easy to
identify each LED. When selecting a LED you
will get to the submenu with all the settings
for that specific LED.
Simple setup of one warning LED.
The setup of a warning LED consist of several
settings. Here is a short explanation of each
setting.
Channel: The channel is the most important
setting. A popup lets you select the channel
you want.
Max: The maximum value of the channel
before the warning LED is active. When the
channel gets above this value, it will warn you.
Min: The mimimum value of the channel be-
fore the warning LED is active. When the chan-
nels gets below this value, it will warn you.
Ignore under: If the minimum value is set,
the ignore under value can be used too. To
avoid a constant warning when the channel
value is below the minimum warning, this