Safety Precautions - Heatmaster G Series Operation And Maintenance Manual

Read and understand all precautions before operating
the furnace .
This furnace needs a periodic inspection for proper
operation . It is against federal regulations to operate
this furnace in a manner inconsistent with operating
instructions in this manual .
Save these instructions. Retain this manual as long as
youown your G Series outdoor furnace. Carefully read
and follow these directions.
DANGER
Do not start the fire with or burn garbage, gasoline,
naphtha, engine oil or other inappropriate materials .
Only competent persons with a sound understanding
of this heating method that are qualified and trained
should operate this furnace. Improper firing could result
in personal injury and/or damage to the unit and void
warranty .
ATTENTION
USE APPROVED FUELS ONLY!
—
The person(s) operating this furnace must comply
—
with all applicable local and state laws or other
requirements.
The person(s) operating this furnace is responsible to
—
run it in such a way so that it does not cause a public or
private nuisance. Consult with local authorities prior to
installation to adhere to local laws and ordinances .
DO NOT OVER FIRE THIS HEATER. Attempts to
—
achieve heat output rates that exceed the heater
design specifications can result in permanent damage
to the heater .
WARNING
All installations and operations of your furnace must
—
follow state, provincial, and local laws pertaining to
operations, wiring, plumbing and building codes.
All models operate at atmospheric pressure . DO NOT
—
obstruct, block or plug the overflow vent tube in any
way, which is located on top of the furnace .
6 Heatmaster G Series Furnace Operating Manual
SS

SAFETY PRECAUTIONS

When installing the furnace, the chimney should
—
never be connected to a chimney flue serving another
appliance .
DO NOT operate furnace in event of power failure .
—
Use caution when opening the firebox and ash cleaning
—
doors. Push the by-pass handle towards the front of the
furnace or push the loading switch and slowly crack the
door open for at least 20 seconds before fully opening
the door .
DO NOT use chemicals or fluids to start the fire.
—
Risk of Fire:
DO NOT operate with fuel loading or ash removal
—
doors open .
DO NOT store fuel or other combustible material within
—
marked installation clearances .
Inspect and clean flues and chimney regularly.
—
This appliance should not be installed in a location
—
where a corrosive atmosphere, flammable gas or
vapour, combustible dust or combustible fibers may
be present. If flammables are present in the building,
ensure ducts, vents and doorways between the rooms
are sealed so as to not allow vapours or fibers to travel
to the appliance .
CAUTION
DO NOT start or operate furnace without checking the
—
heating fluid. The furnace must be filled until heating
fluid comes out the vent pipe on top of the furnace.
Check for buried cables and utility lines before digging
—
the trench to your furnace .
For safety and proper temperature control keep all
—
doors closed during operation .
Hot Surfaces: Keep children away . Do not touch during
—
operation .
ATTENTION: DO NOT CONNECT THIS UNIT TO A
CHIMNEY FLUE SERVING ANOTHER APPLIANCE.