Hardware Installation - Advantech WLAN-9100 Manual

RS232 Port (Console Port)
The RS232 port is used for configuring the WLAN-9100. Use a null-modem RS232 cable
when you desire to configure the WLAN-9100 under console mode. See the section "Access
Point Console" on page 7 for detailed information.

2-4 Hardware Installation

Take the following steps to set up your WLAN-9100.
Site Selection
¡
Before installation, determine the Access Point location. Proper placement of the Access
Point is critical to ensure optimum radio range and performance. You may use the Site
Survey and Access Points Browser utility (The utilities included with the wireless PC
Card) to choose a proper placement for your WLAN-9100. Typically, the best location
to place your WLAN-9100 at your site is the center of your wireless coverage area. Try
to place your mobile stations within the line of sight.
performance of the Access Point.
Access Point Placement
¡
You can place the Access Point on a flat surface such as a table or cabinet, or mount the
unit on a vertical surface like a wall. The integrated antenna of your WLAN-9100
performs best in an open environment with as few obstructions as possible. In most
situations placing the Access Point as pictured below will provide satisfactory
performance results.
Connect the Ethernet Cable
¡
The WLAN-9100 Wireless LAN Access Point supports 10/100M Ethernet connection.
Attach your UTP Ethernet cable to the RJ-45 connector on the WLAN-9100. Then
connect the other end of the RJ-45 cable to a hub or a station. Please be aware that, use
the MDI port to connect the WLAN-9100 to a hub. Otherwise, please use the MDI-X
port to connect the WLAN-9100 to a computer/station.
-6-
Obstructions may impede