Advertisement
Quick Links
S E T- U P A N D O P E R A T I O N W I T H R 1 7 2 0 R E M O T E C O N T R O L
For information on how to programme R1710 Motor with the R1722 or R1723 Remote please see the instructions provided in the box
B ATTE RY SPECIFICATION: Li-ion battery, 2000mAH, 7.4V.
M O TO R TO R Q U E / S P E E D : 1.1Nm/25rpm
Antenna
Charge port
Setting button (Red)
SETTING UP THE MOTOR
• The side of the motor mount with the SETTING button should face you.
• The motor antenna should be as straight as possible; otherwise the receiving distance will be reduced.
• Charging - The motor works with Li-ion battery, please charge when the motor stops working or falters please charge the motor by charger
Charging time with the charger is 5 to 6 hours. Please do not leave the motor on permanent charge as this will reduce battery performance.
NOTE: On receiving the motor we recommend fully charging.
A. Remove grease protector ring by opening the split ring and sliding
off the motor body
B. Fit crown by opening the split ring and slide along the motor body
until it meets the motor head.
C. Fit the drive using the cir-clip to secure in position.
D. Attached motor plate with the screws supplied in either left hand
or right hand orientation as required.
R 1 7 1 0 M O T O R
program ming i ns t ru ct i o ns
CHANNEL#
UP
STOP
DOWN
CHANNEL-
CHANNEL+
M O T O R A S S E M B LY
ATTACHING THE SOLAR PANEL
• Make sure the motor has enough charge to operate the blind.
• Attach the solar panel to the charge port on the motor using the
• Place/ fix the solar panel so that it is facing direct sunlight.
Remote Transmitter
1.5m charge cable.
LIMIT
CONFIRM
Advertisement
Related Manuals for Louvolite R1710
Summary of Contents for Louvolite R1710
- Page 1 S E T- U P A N D O P E R A T I O N W I T H R 1 7 2 0 R E M O T E C O N T R O L For information on how to programme R1710 Motor with the R1722 or R1723 Remote please see the instructions provided in the box B ATTE RY SPECIFICATION: Li-ion battery, 2000mAH, 7.4V.
- Page 2 Setting button (Red) Primary Setting button (Red) Secondary PAIRING THE REMOTE WITH THE MOTOR PAIRING AN ADDITIONAL REMOTE WITH THE MOTOR 1. Select the channel for the blind using the CHANNEL +/- button. 1. Hold down the SETTING button on the motor until it jogs 2 times and then release the button.
- Page 3 SET-UP UPPER LIMIT 5. Press UP button on the remote to move the blind up and press STOP when desired upper limit is reached. 6. Press UP button and the motor will run steps to set the upper limit accurately. 7.
- Page 4 R 1 7 1 0 S A F E T Y I N S T R U C T I O N S WARNING: Important safety instructions. Follow all instructions, since incorrect installation can lead to severe injury. Please save these Instructions.