S E T- U P A N D O P E R A T I O N W I T H R 1 7 2 0 R E M O T E C O N T R O L
For information on how to programme R1710 Motor with the R1722 or R1723 Remote please see the instructions provided in the box
B ATTE RY SPECIFICATION: Li-ion battery, 2000mAH, 7.4V.
M O TO R TO R Q U E / S P E E D : 1.1Nm/25rpm
Antenna
Charge port
Setting button (Red)
SETTING UP THE MOTOR
• The side of the motor mount with the SETTING button should face you.
• The motor antenna should be as straight as possible; otherwise the receiving distance will be reduced.
• Charging - The motor works with Li-ion battery, please charge when the motor stops working or falters please charge the motor by charger
Charging time with the charger is 5 to 6 hours. Please do not leave the motor on permanent charge as this will reduce battery performance.
NOTE: On receiving the motor we recommend fully charging.
A. Remove grease protector ring by opening the split ring and sliding
off the motor body
B. Fit crown by opening the split ring and slide along the motor body
until it meets the motor head.
C. Fit the drive using the cir-clip to secure in position.
D. Attached motor plate with the screws supplied in either left hand
or right hand orientation as required.
R 1 7 1 0 M O T O R
program ming i ns t ru ct i o ns
CHANNEL#
UP
STOP
DOWN
CHANNEL-
CHANNEL+
M O T O R A S S E M B LY
ATTACHING THE SOLAR PANEL
• Make sure the motor has enough charge to operate the blind.
• Attach the solar panel to the charge port on the motor using the
• Place/ fix the solar panel so that it is facing direct sunlight.
Remote Transmitter
1.5m charge cable.
LIMIT
CONFIRM