Table of Contents
Advertisement
Quick Links
MOTOR ASSEMBLY
ƒ Fit crown by sliding along the motor body until it meets the
ƒ Fit the drive using the cir-clip to secure in position.
ƒ Attach the motor plate with the screws supplied in either left
hand or right hand orientation as required.
KEY FEATURES
ƒ DC power supply with energy saving patented design, 7.4V
2600mAh (R1912) 3000mAh (R1918) Lithium battery built-in.
ƒ Setting limits by remote control. Up to 6 limits, including
upper/lower limit and 4 intermediate positions.
ƒ 433.92MHz radio control.
ƒ Short/open circuit protection
ƒ Patented helical gear design, noise level lowered to 30dB.
Remote LAYOUT
LED CHANNEL
INDICATOR
UP
STOP
DOWN
R 1 9 1 2 & R 1 9 1 8 L I T H I U M M O T O R
Operating Instructions
LED CHANNEL
INDICATOR
CHANNEL
BUTTON
R1940 - 1CH
Push button
ATTACHING THE SOLAR PANEL
ƒ Make sure the motor has enough charge to operate the blind.
ƒ Attach the solar panel to the charge port on the motor using the
1.5m charge cable.
ƒ Place/ fix the solar panel so that it is facing direct sunlight.
POWER SOURCE & CHARGING OPTIONS
Built-in Li-ion battery supply. Recharged using an external charger. On
a full charge can be used up to 6 months. Charging time is 6-8 hours.
UP
STOP
DOWN
R1942 - 6CH - WH
Push button
Also available in black
LED CHANNEL
INDICATOR
UP
STOP
DOWN
CHANNEL
BUTTON
R1944 - 16CH
Push button
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Louvolite R1912
Summary of Contents for Louvolite R1912
- Page 1 ƒ DC power supply with energy saving patented design, 7.4V a full charge can be used up to 6 months. Charging time is 6-8 hours. 2600mAh (R1912) 3000mAh (R1918) Lithium battery built-in. ƒ Setting limits by remote control. Up to 6 limits, including upper/lower limit and 4 intermediate positions.
- Page 2 MOTOR HEAD REMOTE PROGRAM/ POWER BUTTON CHARGE PORT SET BUTTON ON/OFF BATTERY PULL TAB MUST BE REMOVED TO INITIATE BATTERY CONTACT SCREW TO SECURE BATTERY WARNING CONTAINS New or used batteries can cause severe or fatal injuries in 2 hours or less if swallowed or placed inside any part of the body. HAZARDOUS BATTERY KEEP Seek medical attention immediately if you suspect the battery has been swallowed or placed inside any part of the body.
- Page 3 SETTING LOWER AND UPPER LIMIT Once the limits are set the system will exit the command automatically. Both limits must be set to exit mode. 1. Lower Limit - Press SET on the programmed remote for 2. Press DOWN to the desired lower limit position, then press STOP. Press SET again 1 second for 1 second the motor will oscillate once, the lower limit is now set.
- Page 4 ADDING A REMOTE 1. Press and hold STOP on the programmed remote for 5 2. Press UP on the new remote. The motor oscillates again, the new remote is now seconds. The motor oscillates once. added. CHANNEL LOCKING & UNLOCKING Channel Locking - Using the LEFT or RIGHT button, select the Channel Unlocking - Using the LEFT or RIGHT button, select the desired channel desired channel you wish to lock the remote on.
Need help?
Do you have a question about the R1912 and is the answer not in the manual?
Questions and answers