Table of Contents
Advertisement
Putting the SR 2020-D into operation
Mounting two SR 2020-D side by side
Place the two transmitters side by side upside-down onto a flat surface.
Align the jointing plate
Secure the jointing plate
screws (M 3x6).
Hook the two rack mount "ears"
Secure the rack mount "ears"
head screws (M 3x6) respectively. If you wish to mount the antenna connections to the
front of the rack, use the rack mount "ears" of the optional GA 3030 AM antenna mount.
Slide the transmitters into the 19" rack.
Secure the rack mount "ears"
Mounting only one SR 2020-D
When mounting only one transmitter into the rack, use the blanking plate
second transmitter.
Hook the two rack mount "ears"
Secure the rack mount "ears"
screws (M 3x6) respectively.
Secure the blanking plate
recessed head screws (M 6x10).
If you are not front mounting the BNC output connector, insert the two blanking plugs
into the holes of the blanking plate.
Slide the transmitter into the 19" rack.
Secure the rack mount "ears"
10 | SR 2020-D
15
over the holes in the bottom sides of the transmitters.
15
to the transmitters using eight of the supplied recessed head
14
to the front panels of the transmitters.
14
to the transmitters using two of the supplied recessed
14
to the rack.
14
14
to the front panel of the transmitter.
14
to the transmitter using two of the supplied recessed head
13
to one of the rack mount "ears"
14
to the rack.
14
15
13
14
using two of the supplied
instead of the
16
Advertisement
Table of Contents
