Set timer as described overleaf:
Model E/C-STC Timer Control Valve Start –Up Procedures
Fig 6
Setting the Timer
Expose the timer assembly (Fig 6) by removing the black cover. This is done by gently
lifting the cover upwards.
1. Manually dial the various regeneration positions by turning the control knob on the front
of the control clockwise until the indicator shows that the softener is in the desired control
position.
2. Manually turn clockwise the control to the 'Rinse Backwash' position and allow water to
flow at the drain for 3-4 minutes. Then proceed to 3.
3. Turn on the electrical supply.
4. Manually fill the brine tank through the salt fill aperture with approximately 6 inches of
tap water using a jug or similar container.
Version 1. 1/12
9