Important: Make sure that no part of the hose, or pipe, run uphill, is kinked, or runs higher
than the overflow outlet. The overflow must always run down hill.
Do not seal the join between the wider piping and the overflow to prevent an air lock forming
(see Fig. 5 ) and DO NOT join the overflow hose to the drain hose - This WILL cause a
flood during the water softeners regeneration cycle.
OVERFLOW SETUP
(5) CONNECT THE ELECTRICITY SUPPLY
The water softener must be wired into a permanent electrical supply i.e. a fused spur
connection.
Version 1. 1/12
7