Zanussi ZYB 460 User Information page 20

20 electrolux
10.Repeat the procedure described in point 9. for the
middle pane marked by a decorative frame on 4 sides
(Fig. 8).
Clean the oven door with lukewarm water and a soft cloth.
Do not use products such as scouring pads, steel wool,
abrasive sponges or acids because they could damage
the special heat-reflecting surface of the internal panes of
glass.
After cleaning, reassemble the panes in the door and then
the oven door, following the procedure described above
in reverse. Make sure you reposition the panes correctly.
To perform this operation correctly, proceed as
follows:
a) the decorated middle pane with a frame on the 4 sides
must be reassembled so that the screen-printing is
facing outwards. The side of the pane of glass is
correct if you do not feel any roughness near the
screen printing when you pass your fingers over the
surface.
The middle pane of glass must be put back into the
right seats as shown in Fig. 9.
b) the uppermost pane must be reassembled as shown
in Fig. 10.
After the panes of glass have been reassembled in the
oven door, perform the procedure described in point 8. in
reverse to ensure they are locked.
20
2
1
Fig. 8
Fig. 9
Fig. 10