Soundstream Granite 110.2 User Manual page 7

AMPLIFIER LOCATION AND MOUNTING
The Soundstream Granite 110.2 amplifier employs highly efficient
circuitry and a unique Chassisink TM design to maintain lower operating
temperatures. When mounting the amplifier, it should be securely
fastened to the vehicle, away from moisture, stray or moving objects,
and major electrical components (electrical motors, fuel pumps, etc.).
To provide adequate ventilation, mount the amplifier so that there are
at least two inches of freely-circulating air above and to the sides of it.
Before mounting the amplifier, make certain the amplifier is configured
correctly for your system.
BRIDGING/MONO
If used in dedicated mono, set the switch to the mono setting and
follow the wiring diagram below.
If used in Mixed Mono, set the switch to the stereo position and follow
the wiring diagram below.
XXX DIAGRAMS XXX
BASS EQUALIZATION
If the Granite 110.2 is being used to drive a subwoofer, you may want
to activate the subwoofer equalization circuit by throwing the switch to
the "XXX" position. Activating the circuit also engages a subsonic filter
at 45 Hz. The subsonic filter is designed to remove the very low
frequency bass information that may damage subwoofers.
CROSSOVER SETTINGS
The Granite 110.2 can be configured to operate full range (for a set of
satellite speakers or coaxials), low pass (for subwoofers), or high pass
(for satellites or coaxials while another amp driving the subwoofers).
XXX DIAGRAMS XXX
A. Using the amplifier as a template, mark the mounting
surface.
B. Remove the amplifier and drill the holes.
C. Mount the amplifier to the surface using the provided
hardware.