Ursalink UC1152 User Manual page 18

UC1152.
The TX (transmit power) setting is used to control
TXPower
the transmission power of the device.
Number of seconds before receive windows are
Join Delay1
opened for join.
The Join Accept Delay between the end of the Tx
Receive Delay1
and the Join Rx Window 1.
The Join Accept Delay between the end of the Tx
Receive Delay2
and the Join Rx Window 2.
The maximum number of the device to resend the
Join Trials join request when the device failed to join the
network.
The maximum number of the device to resend the
data packet if no ACK is received after the specified
ReTx
time.
(Must check Confirmed Mode)
RX2 Datarate for second receive window, which must be
Datarate the same with Tx Datarate of gateway.
RX2 Channel
The frequency for second receive window.
Frequency
ACK Time in milliseconds to wait for ACK before retry of
Timeout confirmed downlink.
Duty Cycle
Check to enable Duty Cycle.
Switch
Number of minutes in sliding windows for duty
Duty Cycle
cycle restrictions.
The number of data frames which sent uplink to the
Uplink Frame
network server .It will be incremented by the end-d
Counter
evice and received by the end-device.
UC1152 User Guide
16
Specified in the
LoRaWAN™
Regional
Parameters
Specified in the
LoRaWAN™
Regional
Parameters
Specified in the
LoRaWAN™
Regional
Parameters
0
3
2-SF10
Specified in the
LoRaWAN™
Regional
Parameters
2000
Enable
0.
The 0 means
using the
standard Duty
Cycle which is
specified in the
LoRaWAN™
Regional
Parameters
0
18