United States call toll-free 1-800-672-7722 ext. 7852 between 8:00 AM and 5:00 PM EST. Instruction manual An OHAUS product service specialist will be available to provide assistance. Outside the USA, please visit our web site, www.ohaus.com to locate the Ohaus office nearest you. Serial Number: Date of Purchase:...
Always ensure the power is disconnected from persons involved in the disposal and recycling of the equipment from health the unit prior to any cleaning. If the unit ever requires service, contact your Ohaus hazards.
Operation of this equipment in a residential area is likely to cause harmful Alternating Current interference in which case the user will be required to correct the interference at his own expense. Changes or modifications not expressly approved by Ohaus Corporation could void the user’s authority to operate the equipment.
SPECIFICATIONS Overall dimensions (L x W x H): 7.9 x 6 x 5” (20.1 x 15.2 x 12.7cm) Top plate dimensions: 4 x 4” (10.2 x 10.2cm) Top plate material: ceramic Electrical (50/60 Hz) Hotplate/Fixed Temp Hotplate: 120 volts: 1.8 amps, 200 watts 230 volts: 0.9 amps, 200 watts Hotplate-Stirrer: 120 volts:...
MINI HOTPLATE/HOTPLATE-STIRRER HEATING OPERATING INSTRUCTIONS 1. Get ready: 3. Adjust temperature: Turn the heat knob to its off position. Plug the power cord into a properly grounded Temperature adjustments can be made without interrupting heating by turning the outlet. Place a vessel with solution and the appropriate accessories in the center indicator knob counter-clockwise to increase heat, or clockwise to decrease heat.
MINI STIRRER/HOTPLATE-STIRRER STIRRING OPERATING INSTRUCTIONS The Stirrer/Hotplate-Stirrer is designed to enable stirring at very slow speeds. STIRRING OPERATING TIPS The stirrer increases speed at a steady rate until the set-point is reached, if the spin 1. Get ready: bar is too large or the liquid is too viscous, the stirrer may not reach its set-point. The The stir knob has a built in on-off switch at its extreme counter-clockwise position.
TECHNICAL SERVICE For information or technical assistance contact your local Ohaus representative or visit ohaus.com. TROUBLESHOOTING Problem Cause Solution Reduce volume or viscosity. Unit will not reach desired speed Sample volume or viscosity If problem persists, please contact your Ohaus representative for repair.