Troubleshooting - AEG CD710M User Manual

38 www.aeg.com
The top lamp
1. Turn the lamp glass cover to remove
it.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or oper-
ate the oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Possible cause
The oven is not connected
to an electrical supply or it is
connected incorrectly.
The oven is turned off.
The clock is not set.
The necessary settings are
not set.
The automatic switch-off is
on.
The Child Lock is on.
The fuse is blown.
The lamp is defective.
There is an electrical fault.
You left the dish in the oven
for too long.
Remedy
Check if the oven is correctly
connected to the electrical
supply (refer to the connec-
tion diagram if available).
Turn on the oven.
Set the clock.
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Refer to "Using the Child
Lock".
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
• Turn off the oven with the
house fuse or the safety
switch in the fuse box
and turn it on again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.