Sony GIGAJUKE NAS-C5E Operating Instructions Manual page 32

8
Select the source you want to play.
If you select [Yes], the currently playing
source will be played when the start time
is reached. If you select x-DJ as the source,
CH. 001 will be played no matter which
channel you select.
If you select Internet Radio as the source,
the station currently being received will be
set.
If you select [No], the source that you set
the last time will be played.
9
Press VOLUME +/– to adjust the
playback volume.
If you select [Yes], the current volume is
set when the start time is reached.
If you select [No], the volume you set the
last time remains set.
"Confirm on-timer settings. " appears.
10
Select [OK].
The On-timer is set and
the playback display.
3 minutes prior to the start time, the
device starts preparing for the On-timer
playback.
20 seconds before the finish time, the
volume turns down gradually and the
device goes into standby mode
automatically after the finish time.

Tips
If you do not want to set the finish time, set it to

[––:––].
While the On-timer is set in the Home Network

function, the play mode changes temporarily to [1
repeat]. After completing the setting, the play
mode is restored.
If the specified track is erased or the specified

radio station cannot be received before the On-
timer starts, an alarm sounds at the start time.
Press any button to stop the alarm. However, if you
erase the specified track or the unit is disconnected
from the Internet within 3 minutes before the start
time of the On-timer setting, the alarm does not go
off.
If the time periods for the timer 1 and timer 2

overlap, the timer which start time is set earlier
than the other one overrides the later one.
32
GB
Notes




appears on
You cannot set On-timer in the Audio In function.
The On-timer setting is erased if you disconnect
the AC power adaptor.
If the unit is already turned on 3 minutes before
the start time of On-timer, the On-timer is not
activated.
If the On-timer has been set, do not operate the
unit within 3 minutes of the start time. If you do,
the On-timer may not function.