Bosch A4VG A4VG 32 Series Instruction Manual page 29

Transport with lifting strap
▶ To do this, screw an eye bolt completely into the female thread on the drive shaft.
The thread size is stated in the installation drawing.
▶ Make sure that the eye bolt can bear the total weight of the axial piston unit plus 20%.
You can hoist the axial piston unit as shown in Fig. 7 with the eye bolt screwed into
the drive shaft.
Fig. 7: Fixing the eye bolt
wARnInG Danger from suspended loads.
During transport with a lifting device, the axial piston unit can slip out of the lifting
strap and result in injury.
▶ Use the widest possible lifting strap.
▶ Make sure that the axial piston unit is securely fixed with the lifting strap.
▶ Only guide the axial piston unit by hand for fine positioning and to avoid oscillations.
▶ Never stand or put your hands under a suspended load.
▶ Place the lifting strap around the axial piston unit in such a way that it does not
pass over attachments (e.g., valves, piping) and that the axial piston unit is not
suspended from attachments (see Fig. 8).
Fig. 8: Transport with lifting strap
Transport and storage
RE 92003-01-B/12.2015, A4VG Series 32, Bosch Rexroth AG
29/68