Signode PRHM-34 Operation, Parts And Safety Manual page 12

OPERATING INSTRUCTIONS, Continued
4. TENSIONING THE STRAP
While standing to one side of the strap,
press the tension lever (Green lever) all
the way down. The catch link will then
engage the tension lever holding it in the
down position.
The strap will tension around the package
until the proper tension level has been
reached, at which time the air motor will
stall. Refer to page 9 for detailed
information about adjusting strap tension.
NOTE: If strap alignment is unsatisfactory
and it becomes necessary to shut off the
tool during the tensioning portion of the
cycle, push the catch link (Red lever) over
to the left, releasing the tension lever. Cut
off the strap and apply a new strap in a
more favorable position.
5. FORMING THE STRAP JOINT
Press down and hold the sealer lever
(Blue lever). Air will be then routed to the
top of the cylinder enabling the sealer
mechanism to notch the seal/strap and
cut-off the TOP STRAP. The tool will
disengage from the seal and strapped
package leaving the cut off end of the
strap clamped under the feedwheel.
12