Remote Control Storage; Locking The Remote Control; Replacing The Remote Control Batteries - Jeep Grand Cherokee 2013 Operating Information Manual

15. SETUP – When in a video mode, press the
SETUP button to access the display settings
(see the display settings section) to access the
DVD setup menu, select the menu button on the
radio. When a disc is loaded in the DVD player
(if equipped) and the VES™ mode is selected
and the disc is stopped, press the SETUP
button to access the DVD Setup menu. (see the
DVD Setup Menu of this manual.)
16. BACK – When navigating in menu mode,
press to return to the previous screen. When
navigating a DVDs disc menu, the operation
depends on the disc's contents.
17. – In radio modes, press to seek to the
previous tunable station. In disc modes, press
and hold to fast rewind through the current
audio track or video chapter. In menu modes
use to navigate in the menu.
18. ENTER – Press to select the highlighted
option in a menu.
19. / NEXT – In radio modes, press to select
to the next station. In disc modes, press to
advance to the next audio track or video chap-
ter. In menu modes, use to navigate in the
menu.

Remote Control Storage

The video screen(s) come with a built in storage
compartment for the remote control which is
accessible when the screen is opened. To re-
move the remote, use your index finger to pull
and rotate the remote towards you. Do not try to
pull the remote straight down as it will be very
difficult to remove. To return the remote back
into its storage area, insert one long edge of the
remote into the two retaining clips first, and then
rotate the remote back up into the other two
retaining clips until it snaps back into position.
The Remote Control Storage

Locking The Remote Control

All remote control functionality can be disabled
as a parental control feature.
• To disable the Remote Control from making any
changes, press the Video Lock button and follow
the radio's instructions (select menu, rear ves,
lock). If the vehicle is not equipped with a DVD
player, follow the radio's instructions to turn
Video Lock on. The radio and the video
screen(s) indicate when Video Lock is active.
• Pressing the Video Lock again or turning the
ignition OFF turns Video Lock OFF and allows
remote control operation of the VES™.
Replacing The Remote Control
Batteries
The remote control requires two AAA batteries
for operation. To replace the batteries:
• Locate the battery compartment on the back
of the remote, then slide the battery cover
downward.
• Replace the batteries, making sure to orient
them according to the polarity diagram shown.
• Replace the battery compartment cover.
199