Table of Contents
Advertisement
5.
Put the vacuum cleaner away, or make it ready for transport after use.
Keep the vacuum cleaner in a dry place and inaccessible to children.
6.
Do not use force.
Do not use force when operating the vacuum cleaner. Do not step on the hose, or the electrical cord.
7.
Choose the correct tool, accessories for the task.
Do not use badly proportioned or light tools for heavy tasks. Do not use tools for anything they are
not intended for.
8.
Choose suitable working clothes.
9.
Personal protective equipment.
Put on eye and/or hear protection, if necessary. Put on respirator in dusty environments.
10.
Protect the electrical cord.
Never carry the vacuum cleaner by the electrical cord. Do not remove the plug from the socket by
pulling the electrical cord. Keep the electrical cord away from heating sources, oil and sharp edges.
11.
Choose a safe working position so that there will be no risk of falling in the hose and cord.
12.
Keep the machine and equipment in good repair.
Keep the vacuum cleaner clean and dry and follow the instructions of the chapter about
maintenance.
13.
Cut off the electricity supply when the vacuum cleaner is not in use.
Remove the plug from the socket before maintenance, repair and when the vacuum cleaner is not in
use.
14.
If extension cords are used out of doors, they must be
approved for this.
If extension cords are used, the following guidelines must
be observed.
15.
Show attention and be rested.
The vacuum cleaner must not be used, if the user is tired, sleepy or sick or under the influence of
alcohol or drugs / medicine.
16.
Check for damage.
Check the vacuum cleaner for damage. Check that the shields etc. have been properly fastened.
Check the electrical switches, and have an authorized service mechanic replace them, if they are
damaged. Do not use the vacuum cleaner, if it cannot be started and/or stopped at the switch.
V. Brøndum A/S
User Manual - English
RONDA
2800H
®
Length of cord
Cross section
in meters
<16A
Up to 20 m
Ø1,5mm² Ø2,5mm²
20-50 m
Ø2,5mm² Ø4,0mm²
<25A
Page 12
Advertisement
Table of Contents
