Table of Contents
Advertisement
DIFFICULTY IN OPERATING THE BLADE CONTROL
SYSTEM
Misaligned jackscrew bearing. Loosen and realign.
Improper lubrication. See LUBRICATION
REQUIREMENTS.
Bent jackscrew. Replace jackscrew and flexible joint
assembly.
UNEVEN COVERING MATERIAL REMOVAL
Excessive material build-up on caster wheel face
surface. Remove material. Readjust wheel scraper to
wheel gap setting: .03/.06 inch (.8/1.5 mm).
Excessive caster wheel bearing wear. Replace caster
wheel and shoulder type cap screw.
Excessive axle shoulder type cap screw wear.
Replace cap screw. Check caster wheel bearing for
wear. Replace as necessary.
Damaged elastomeric rubber mount(s). Replace
mount(s).
Damaged exciter plate. Replace plate.
Bent blade. Replace blade.
Storage
Proper procedure for long term storage of the Bon
Floor Stripper will protect it against the effects of
corrosion and damage. If the Bon Floor Stripper is not
to be operated for a period of 30 days or more,
proceed to store as follows:
1) Never store the Bon Floor Stripper with the blade
or ceramic tile ripper attachment installed. Remove
the blade or ceramic tile ripper attachment from the
Bon Floor Stripper per the procedures outlined in this
manual.
Do not store the Bon Floor Stripper with the
b l a d e o r c e r a m i c t i l e r i p p e r a t t a c h m e n t
a t t a c h e d . T h i s c o n f i g u r a t i o n c a n r e s u l t i n
property damage and/or personal injury.
2) Clean all accumulated foreign material from the
Bon Floor Stripper utilizing an appropriate safety sol-
vent.
Observe all applicable safety precautions for
the solvent.
3) Check all visible parts for wear, breakage or dam-
age. Order any part required to make the necessary
repair. This will avoid a needless delay when operat-
ing the Bon Floor Stripper at next use.
4) Apply a dry film lubricant to all exposed metal
components to prevent rust.
5) Block the bottom of the main frame to prevent
machine weight against the exciter plate. This
procedure will reduce impact loads to the elastomeric
rubber mounts, minimize deflection and increase
service life.
6) Store the Bon Floor Stripper inside. If the Bon
Floor Stripper must be stored outside, protect it with a
suitable covering.
Specifications
FRAME
STRUCTURE - Unitized, welded steel plate.
DRIVE SYSTEM - Random orbit, direct shaft mount.
NUMBER OF ELASTOMERIC RUBBER MOUNTS - 4.
WIDTH - 14-1/2 inches (368 mm).
WIDTH (AT OPERATOR HANDLE) - 23" (584 mm).
LENGTH (HANDLE FOLDED) 24" (610 mm).
LENGTH (OPERATING CONFIGURATION) - 34" (864 mm).
HEIGHT (HANDLE FOLDED)-23" (584 mm).
HEIGHT (MAXIMUM HANDLE EXTENSION) - 42" (1067 mm).
GENERAL
WEIGHT (WITH EXTERNAL WEIGHT
LESS BLADE)
EXTERNAL WEIGHT, EACH
4430 Gibsonia Rd. • Gibsonia, PA 15044 • USA • www.bontool.com
32
130 lbs
(59 kg).
14 lbs (6 kg).
Advertisement
Table of Contents
