DURKOPP ADLER 867 Additional Instructions page 10

Fig. 3: Connecting the remaining thread monitor on Classic machines (2)
(4) - Cable clamps
4. Fasten the cables with the cable clamps (4) to the base plate of the
5. Screw the remaining thread monitor carrier plate (1) with the circuit
Fig. 4: Connecting the remaining thread monitor on Classic machines (3)
(6) - Cable
6. Route the cable (6) through the cable holder (7) in the machine arm:
7. Connect the cable (6) to plug connection X24 of the valve circuit board.
8. Guide the cables of the remaining thread monitors through the holes
8
④
remaining thread monitor control.
board (2) into the base plate using the screws (5).
⑥
from the remaining thread monitor control to the valve circuit board.
in the base plate and fix them to the existing cables with cable tie.
Assembling the remaining thread monitor
⑤
(5) - Screw
⑦
(7) - Cable holder
Additional Instructions 867/867-M PREMIUM - 00.0 - 07/2018
X24