Assigning An Acl To A Port - H3C S3100 Series Operation Manual

Operation Manual (For Soliton) – ACL
H3C S3100 Series Ethernet Switches
Note:
After an ACL is assigned to a port group, it will be automatically assigned to the ports
that are subsequently added to the port group.
III. Configuration example
# Apply ACL 2000 to port group 1 to filter the inbound packets on all the ports in the port
group.
<Sysname> system-view
[Sysname] port-group 1
[Sysname-port-group-1] packet-filter inbound ip-group 2000

1.3.4 Assigning an ACL to a Port

I. Configuration prerequisites
Before applying ACL rules to a VLAN, you need to define the related ACLs. For
information about defining an ACL, refer to section
section 1.2.3 Configuring Advanced
section 1.2.5 Configuring an IPv6
II. Configuration procedure
Table 1-9 Apply an ACL to a port
Operation
Enter system view
Enter Ethernet port
view
Apply an ACL to the
port
Note:
You cannot assign an ACL to a member port of a port group.
III. Configuration example
# Apply ACL 2000 to Ethernet 1/0/1 to filter the inbound packets.
ACL, section
ACL.
Command
system-view
interface interface-type
interface-number
packet-filter inbound acl-rule
1-15
Chapter 1 ACL Configuration
1.2.2 Configuring Basic
1.2.4 Configuring Layer 2
Description
—
—
Required
For description on the
acl-rule argument, refer
to ACL Command.
ACL,
ACL, and