Troubleshooting And Maintenance - Launch TWC-512RMB Operation Manual

NOTICE:
For some tires could be disassembled by only using the bead breaking disc， so it is enough continue the
third step until the tire was detached off.
Combination with the bead-breaking disc make it is easer to demount the wider tires and sport car tires.
Raise the lower bead up to center drop of the rim with the help of the bead-breaking disc.
Hook the detached part of tire on the mounting head.
Remove the bead-breaking disc; turn the turntable clockwise until the lower bead comes off the rim.
9.3 MOUNT TIRES
1） Set up the first bead according to instruction
2） WARNING!
Push away the tool holding arms to avoid danger of collision!
Move the mounting head and depress it to a depth of 3 cm blow the
upper side of the rim.
DANGER!
3） Please pay special attention during this procedure，pressing the
rim with the mounting head is not permitted. It will lead to danger.
Keep away hands from the mounting head.
4） Depress the corresponding pedal to turn the turntable, the
mounting head mechanism will turn also. Depress the tire blow into
the rim. During this procedure，it is free from any human interference
or other assistors.
Phenomena
Switch level is not flexible
1）Disconnected with compressed air
Analysis
2）Air hose is folded or broken
3）Valve is broken
1）Connect with the compressor according to the manual
Solution
2）Inspect the air hose， replace the broken hose and joint
3）Please contact with the department of after sale

10. TROUBLESHOOTING AND MAINTENANCE