Control Panel Menus - Philips Video System Manager Pro Series User Manual

Control Panel Menus

LCD Menu
Startup Messages
Status
Input
Version
IP Address
Map Info
Map Size
Video Size
Frame Rate
Brightness
Black Level
White Level
Smooth Frames
Smooth Pixels
Sync Packets
25 VSM Pro User Guide
Message / Menu
Option
Philips
VSE Pro
Running, Paused, or
Shutting Down
DVI
VGA
Composite
[test pattern file name]
[firmware version]
10.1.3.101
[map file name]
[map resolution]
[input file resolution]
Frame Rate
0 – 100
0 – 255
0 – 255
No Smoothing
1 – 5 Frames
No Smoothing
1 – 5 Pixel Rings
Always Sync
Never Sync
Map Settings
Description
The startup prompt.
Displays the current operational status of the
VSE Pro.
Displays the selected media input type.
Displays the version and build number of the
system software installed on the VSE Pro.
Displays the VSE Pro IP address, which is
hard-coded to 10.1.3.101.
This menu displays the name of the currently
loaded video map file. Maps are uploaded to the
VSE Pro at IP address 10.1.3.101 via the User
Interface.
The size of the currently loaded VMT map. The
default resolution is 1024 x 768.
The detected resolution of the video input.
Displays the rate at which video frames are sent
to the fixtures.
Use the up and down navigational buttons to
adjust the brightness of the video output. The
default setting is 100% brightness.
Set a cutoff value for displaying black pixels
(0 by default).
Set a cutoff value for displaying white pixels
(255 by default).
Configure noise filtering settings to correct a
'steppy' video signal.
Configure noise filtering settings to correct a
'noisy' video signal.
Configure packet synchronization to improve
network performance.