Honda Wave 110 Alpha 2018 Owner's Manual page 81

Remove the rear axle shaft, drive chain
8.
adjusters, side collars and rear wheel from
the swingarm.
Drive chain
adjusting nut
Drive chain
adjuster
Rear axle
shaft
Installation
To install the rear wheel, reverse the
1.
removal procedure.
Temporarily tighten the rear axle nut.
2.
Tighten the brake stopper arm nut.
3.
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Adjust the drive chain slack.
4.
5.
6.
Torque: 59 N·m (6.0 kgf·m, 44 lbf·ft)
Drive chain
lock nut
7.
Drive chain
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
A used cotter pin may not effectively secure a
fastener. Always replace a used cotter pin
with a new one.
P. 65
2
Tyre Puncture
Adjust the rear brake pedal freeplay.
P. 58
2
Tighten the rear axle nut.
After installing the wheel, apply the brake
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
Removing Wheels
u
77