Device Overview - Clinton Electronics CE-RP5 User Manual

Attach the main power cord to the PVM. Turn the CE-RP5 power switch to
the ON position. The Record, and Power lights on the front of the CE-RP5 will
illuminate.
corruption.
6

DEVICE OVERVIEW:

1. HD-SDI Output
2. HDMI monitor output
3. Analog Output
4. DC12 Volt Power Input
5. OSD Menu Navigation Buttons (Up, Right, Down)
6. LED Output- Connect a single LED diode to LED + / LED-, which will illuminate in conjunction with the main
recording LED on the front of the device.
8. VIEW MENU AND FILES
7. Event Alarm Output- Connect #4 GND / Motion Out : This is a normally closed alarm output which will become
open when triggered by a motion or by an alarm event input.
the back cover
The recorded content can be viewed on the attached display by using the
8. Alarm Input - Connect wires to #1 GND / Alarm In: This alarm input can be configured to Normally Open / included remote control, or by removing the SD card and viewing on your PC.
Normally Closed in the OSD Menu under Power On Setup.
9. USB Service Port - To be used by service personnel only
10. SD-Card Input If removing the card, first power down the device to avoid file corruption.
11. Record / Power LED Indicator lights
12. IR remoter control sensor (side)
13. Power switch
14. HD-SDI Input
01
6 LED-
5 LED+
4 GND
3 MOTION OUT
2 GND
1 ALARM IN
7
8
H.264 FULL HD-SDI RECORDER
9
Clinton Electronics | CE-RP5 User Manual
Device Overview
1
3
2
REC EXIT
with converter
4
5
PLAY MENU/ENTER
10
REC
12
11
PWR
13
14