Basic Live Traffic Identifier
Number Key/Indicator
1
Plunger
2
Fiber groove
3
No signal indicator
4
Left traffic indicator
5
Right traffic indicator Lights if the signal in the tested fiber is left to
6
Signal intensity
7
2-kHz indicator
8
1-kHz indicator
9
270-Hz indicator
10
Low-battery indicator Lights when there is not enough power.
11
Adjusting button
Page 10
Table 4-1. Front-panel board components.
Function
Choose from H 0.25 mm, H 0.9 mm,
and H 3.0 mm adapters.
Place the tested fiber in this slot.
Lights when there is no signal in the tested
fiber.
Lights if the signal in the tested fiber is from
right to left.
right.
Shows the signal intensity level. A higher inten-
sity means a stronger signal.
Lights if the wave frequency is 2 kHz.
Lights if the wave frequency is 1 kHz.
Lights if the wave frequency is 270 Hz.
Used to self-calibrate the identifier.
724-746-5500 | blackbox.com