Connection Via Infrared Port - Sony Ericsson P910i User Manual

This is the Internet version of the user's guide. © Print only for private use.
Set the P910i in mode for
PC connect
• Synchronization.
• Installation of software.
• Backup and restore.
Set the P910i in mode when using
Modem
• P910i as a modem.
• Dial-up network wizard.
You should disable the USB cable connection in these two
cases. In your PC select
Start > Settings > Control Panel > Phone
and disable the COM port to
Monitor Options > COM Ports
which the cable is connected.

Connection via Infrared port

When connecting via the infrared port, make sure that both
devices are placed within one metre from each other and that the
infrared ports have a free line of sight between them.
Both your P910i and the device you connect to must have their
infrared ports activated before communication can begin.
To activate the infrared port on the P910i
1. Go to
Control panel > Connections > Infrared
2. Set the P910i to or
PC connect
.
as required.
Modem
3. Set the port state to or
On On for 10 minutes.
You can also change the infrared port state with the flip closed,
in the application.
Connections
To activate the infrared port on the PC
1. Right click in the status area to the right on the taskbar.
2. Select
Properties
3. Select the Infrared check box
4. Click .
Close
Note Clear the Infrared check box when ready.
Send and receive
You can send items via the infrared port, beam, in any
application if there is a
Send as
. If you receive a beamed item, a dialog box appears with
Infrared
three options: , or
Delete View Done
opens the associated application which shows the item;
saves it in the folder in
Beamed
Connecting to other devices
command. To send, select
. deletes the item;
Delete View
Done
.
Messages
135