Table of Contents
Advertisement
Note!
Icons appearing on your phone's display differ in Voice, Browser,
and Wireless Modem Operation.
1 Press the numeric keys to enter the phone number you want to
call. The number is shown in the display.
Note!
You can press
%$&.
to erase one or more digits in the display, or
press and hold
%$&.
to erase all digits.
The phone is searching for the
optimal wireless system.
The keypad is locked to
prevent inadvertent key presses.
You can set the alarm on your
phone.
You can use the stopwatch on
your phone.
2 Press
<(6
.
, along with the number you are dialing, or
the corresponding Phonebook name, is shown in the display while
your phone accesses the wireless network.
3 When the call is connected,
timer, is shown in your display. The phone number that you
dialed will remain on your screen after you end the call.
4 To end the call, press
12
.
Your telephone temporarily stores numbers you have previously called.
To view these numbers, press
<(6
other digits are in the display. The last number you called is shown in the
display. Press or
to scroll through other stored numbers. You can
place a call to a number shown in the display by pressing
the number. Then you can change or add digits if appropriate. Press
<(6
again to dial the number. You can delete a number from the
Outgoing Calls by pressing
%$&.
. You can save a phone number from
the Outgoing Calls List or Incoming Calls List by pressing and
holding
<(6
while the number is highlighted in the list and by pressing
<(6
again to confirm the addition of the number to your phonebook.
Stop and pause dialing lets you enter groups of numbers with stops
and pauses between each group of numbers. This feature is useful when
you need to dial a phone number and then another number, such as
an access number for an answering machine or voice mail system.
A stop causes the phone to stop transmitting numbers until you
press any key except
. You can enter a stop in a series of digits by
12
pressing and holding until
is shown in the display.
, along with your call
from the Standby screen when no
to display
<(6
Advertisement
Table of Contents
