To Adjust The Needle Drop - Janome Memory Craft 3500 Servicing Manual

TO ADJUST THE NEEDLE DROP

When you select the pattern ( ), the needle drop should be in the center position of the needle
hole in the needle plate.
When the needle swings in maximum zigzag width, the distance between both edges of
The needle hole on the needle plate and the needle drop position should be equal.
1. Turn on the power switch.
2. Select pattern ( ), or pattern ( ) at maximum zigzag width.
3. Loosen the set screw (A).
4. Turn the eccentric pin to adjust the needle drop.
5. Tighten the set screw (A).
Note: check the hook timing after this adjustment.
6