Dc Motor Unit Attaching And Removing - Janome Memory Craft 3500 Servicing Manual

DC MOTOR UNIT ATTACHING AND REMOVING DC MOTOR
To remove:
1. Remove the front panel unit (see page 4).
2. Remove the machine socket unit (see page 22) (no need to pull out the connectors)
3. Cut the cord binder and pull out the motor connector from board A.
4. Remove the screw (A) and cord guide.
5. Remove the motor belt, screws (B) and the motor.
To attach:
6. Attach the DC motor by tightening the two screws (B) slightly.
7. Attach the motor belt and adjust the belt tension.
8. Set the cord guide with screws (A).
9. Secure the cord with the cord binder.
10. Connect the motor connector to the board A.
I 1. Attach the machine socket unit and front panel unit.
20