Description Of The Ceramic Hob Surface Layout; Installation - Candy CHK64C Instruction Manual

Description of the Ceramic hob surface layout

1) 1.20 kW hyperspeed zones (diameter 160
mm)
2) 1.80 kW hyperspeed zones (diameter 200
mm)
Control panel layout
1. Cooking zone rear left control knob
2. Cooking zone front left control knob
3. Cooking zone rear right control knob
4. Cooking zone front right control knob

Installation

Installing the ceramic hob
 The kitchen area should be dry and aired and equipped with efficient ventilation.
When installing the ceramic, easy access to all control elements should be
ensured.
 This is a Y-type design built-in ceramic, which means that its back wall and one
side wall can be placed next to a high piece of furniture or a wall .Coating or
veneer used on fitted furniture must be applied with a heat-resistant adhesive
(100℃).This prevents surface deformation or detachment the coating.
 Hoods should be installed according to the manufacturer's instructions.
Assembly of ceramic hob :
 Make an opening with the dimensions given in the diagram for the hob to be
mounted on the worktop．
 Check seal for perfect fit and overall cover. Lower the ceramic hob into place and
align correctly.
 Using a standard screwdriver, tighten the tension clamps evenly starting at the
centre and moving diagonal, until the built-in rim is tight on the worktop.
5