IBM DS8882F Introduction And Planning Manual page 150

DANGER:
Electrical voltage and current from power, telephone, and communication cables are hazardous. To
avoid a shock hazard:
•
• Do not open or service any power supply assembly.
• Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration
• The product might be equipped with multiple power cords. To remove all hazardous voltages,
• Connect all power cords to a properly wired and grounded electrical outlet. Ensure that the outlet
• Connect any equipment that will be attached to this product to properly wired outlets.
• When possible, use one hand only to connect or disconnect signal cables.
• Never turn on any equipment when there is evidence of fire, water, or structural damage.
• Do not attempt to switch on power to the machine until all possible unsafe conditions are corrected.
• Assume that an electrical safety hazard is present. Perform all continuity, grounding, and power
• Do not continue with the inspection if any unsafe conditions are present.
• Disconnect the attached power cords, telecommunications systems, networks, and modems before
• Connect and disconnect cables as described in the following procedures when installing, moving,
• Sharp edges, corners and joints may be present in and around the system. Use care when handling
DANGER:
(D006)
140
DS8882F Introduction and Planning Guide
When working on or around the system, observe the following precautions:
If IBM supplied a power cord(s)
cord. Do not use the IBM provided power cord for any other product.
of this product during an electrical storm.
disconnect all power cords.
supplies proper voltage and phase rotation according to the system rating plate.
checks specified during the subsystem installation procedures to ensure that the machine meets
safety requirements.
you open the device covers, unless instructed otherwise in the installation and configuration
procedures.
or opening covers on this product or attached devices.
To disconnect:
1. Turn off everything (unless instructed otherwise).
2. Remove the power cords from the outlets.
3. Remove the signal cables from the connectors.
4. Remove all cables from the devices.
To connect:
1. Turn off everything (unless instructed otherwise).
2. Attach all cables to the devices.
3. Attach the signal cables to the connectors.
4. Attach the power cords to the outlets.
5. Turn on the devices.
equipment to avoid cuts, scrapes and pinching. (D005)
Heavy equipment — personal injury or equipment damage might result if mishandled.
, connect power to this unit only with the IBM provided power