Miele WCR 860 WPS Operating Instructions Manual page 73

Fault message at the end of a programme
Problem

Intensive flow: Clean
the filter and jet or
remove foreign
objects from the
pump housing.

Align the machine.
Laundry not properly
spun
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor.
Cause and remedy
The pumps are dirty.
 Clean the pumps as described in "Problem solving
guide . .", Opening the door in the event of a
blocked drain outlet and/or power cut".
 Restart the programme after cleaning.
The jet in the top of the door ring is blocked with fluff.
 Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
 Restart the programme after cleaning.
If the fault message appears again, contact Miele.
The washing machine can still be used but with
reduced functionality.
The Extra which runs at the end of the
Pre-ironing
programme could not be carried out properly.
 Check whether the washing machine is aligned
correctly as described in "Installation – Levelling
the machine".
 Check whether the maximum delivery head of 1 m
has been exceeded.
If the fault message appears again, contact Miele.
The washing machine can still be used but with
reduced functionality.
Problem solving guide
73