Mitsubishi Electric Mr.Slim PUZ-HA42NKA Service Manual page 76

12-1-1. Selecting functions using the wired remote controller <PAR-21MAA>
First, try to familiarize yourself with the flow of the function selection procedure. In this section, an example of setting the room
temperature detection position is given.
For actual operations, refer to steps 1 to 0 .
Mode number
F
E
G
Selecting functions using the wired remote controller
1 Check the function selection setting.
2 Switch to function setting mode. *
(Press A and B at the same time
with stop the remote controller.)
3 Specify refrigerant address 00 (outdoor unit).
4 Specify unit No. 00. (indoor unit)
(Use C and D .)
6 Select mode No. 02
(room temperature detection position).
7 Select setting No. 03 (remote controller fixed).
(Use F and G .)
0 End function display.*
(Press A and B at the same time.)
The above procedure must be carried out only if changes are necessary.
OCH567
Setting number
Refrigerant address
C D
(Specified indoor unit:
5 Enter the setting.
FAN operation)
(Press E .)
Example:
8 Enter the setting.
Selecting room temperature
(Press E .)
detection position
NO
Finished
YES
Unit number
I
A
Modes 01 to 14 can be activated
by pressing buttons
B
simultaneously, and modes 15 to
28 by pressing buttons
J
*For modes 15 and higher ,
press J and B at the same time.
NO
A B
and
B J
and
YES
Change refrigerant
address or unit No.
9
.