Table of Contents
Advertisement
Section 1: Installing a mounting bracket and light fixture during new vinyl
pool construction
10.
Connect all three wires to the corresponding circuit wires in the junction box and secure
the junction box cover in place.
11.
For lights with 2-conductor cords only (no ground wire) connect two wires to the
corresponding circuit wires in the Junction Box, black wire to power, white wire to common
and secure the Junction Box cover in place.
WARNING: Never operate the AquaLumin
10 seconds unless it is totally submerged in water. Without total submersion, the light
assembly will get extremely hot, which may result in serious burns or in breakage of
the lamp or lens. This may result in serious injury to pool users, installer, or bystand-
ers, or in damage to property.
WARNING: Use only the special stainless steel captive screw (see Light
Assembly Parts, item 4, on page 14) provided with this AquaLumin III pool light.
This screw mounts and electrically grounds the housing securely to the AquaLumin
III pool light fixture. Failure to use the screw provided could create an electrical
hazard which could result in death or serious injury to pool users, installers or others
due to electrical shock.
12.
Before operating the light for more than 10 seconds, fill pool until the AquaLumin III pool
light fixture is completely submerged in water. To check for proper operation, turn on main
switch or circuit breaker, as well as the switch which operates the AquaLumin III pool
light.
C. Winterizing:
Light should be left in place for winterization.
(Continued)
®
III Nicheless Pool Light for more than
AQUALUMIN
®
III Nicheless Pool Light Installation Guide
7
Advertisement
Table of Contents
