Table of Contents
Advertisement
2
Contact Technical Support at: (800) 831.7133
Web sites: visit www.pentairpool.com and www.staritepool.com
Kits required for installation
Required for new installation (Contains all parts required to install light in a new installation)
78887700 3/4 inch conduit
78887800 1 inch conduit
The following part may be required for new light in an existing installation (Contains
only the mounting parts on the water side of the vinyl liner)
619547 Bracket Wall Mount Assembly
Follow these guidelines when installing Pentair Aquatic Systems Pool and Spa fixed luminaries:
Before Installing luminaries read the following:
WARNING! Always install a new lens gasket (see part number in User's Guide), when ever
reassembling the light. Failure to do so may permit water to leak into the assembly which
could cause; (a) an electrical hazard resulting in death or serious injury to pool users,
installer, or others due to electrical shock, or (b) breakage of the lamp or lens, which
likewise could result in serious injury to pool user, installers, or bystanders, or in damage to
property.
REPLACE ANY CRACKED PROTECTIVE SHIELD (CRACKED LENS) WITH NEW LENS
AND GASKET.
•
FOR 12 VAC LUMINARIES: ALWAYS USE A SEPARATE SAFETY ISOLATION
TRANSFORMER TO POWER LUMINARIES. See diagram below.
Note: Connect all three light wires (or two light wires) to the corresponding circuit wires in
the Junction Box. For 3-wire connection; connect black wire to power, white wire to
common, and green wire to ground).
•
12 VAC LUMINARIES SPECIFICATION:
120VAC
Luminaires not suitable for direct mounting
on normally flammable surfaces (suitable
ONLY for mounting on non-combustible
surfaces.
AQUALUMIN
®
III Nicheless Pool Light Installation Guide
IMPORTANT NOTICE
, 50/60 Hz
Surface Mount
Advertisement
Table of Contents
